Under your thumb.

Mix · Drag any part of a strip. Outward adds volume. Hold its outer tip to isolate; release to bring the mix back. Tap a stem name to mute.

Quick repeat · Hold the center while playing. Slide down for faster cuts, up for longer loops. Release to return to the song. While holding, tap Repeat to lock your loop.

Repeat · Tap Mix, Repeat, or FX to change modes. Hold either vertical strip and slide through the center: top for longer loops, bottom for faster cuts. Hold either horizontal strip and slide through the center from reverse on the left to forward on the right. Release to return. In Repeat, the bottom arrows nudge an active loop. In Mix and FX, tap an arrow for the previous or next track; hold to reverse or fast-forward.

FX · Tap or slide the vertical strips to select an effect. Drag either horizontal strip right for more or left for less; release to keep the amount. Hold center + volume up to jump here. Tilt FX appears only in this mode. Tap it and allow motion access. Leaving FX turns tilt off. Hold still for a moment, then tilt right to add FX or left to reduce it. The live angle and effect amount appear below the controls. Tap off and on to reset your neutral angle.

The lit section shows your volume setting. Brighter lights pulse with each stem’s audio inside that section. Repeat, reverse, fast-forward, and isolation last while held; volume and FX amount stay set.

In Repeat, tap center to clear loop and speed changes, then tap again to return to Mix. In FX, tap center to return to Mix. In Mix, tap to clear any active changes; with no changes active, tap to pause. The icon shows the next action. Hold center to repeat while playing. Reset mix in these settings clears your changes. Hold + to record your mix; hold again to save.

Loops run from 16 bars down to 1/128. Fast slices extend the hardware's documented loop range. Phone tilt needs HTTPS and motion permission.